Disabling sending pitchbend for key x movement (iP1Mx)

Striso
1

Hi,

I’m trying to reconfigure the Striso to send cc1/cc2 as x/y keymovement. I at least try to get rid of pitchbend on the “iP1Mx” value. Pitch is just too hard for me to control this way.

However, if I set iP1Mx to “2” (breath control), and save the whole config to preset #1 that is selected as the preset to boot into, iP1Mx still sends pitchbend. Even if I load that preset explicitly. Same behavior when setting “127”, meaning “do nothing”.

If I reconnect the Striso as a drive, the web interface (which is very cool BTW) does show iP1Mx as sending cc2. But maybe the board still works from the older configuration? It does go into into “pythagorean” tuning.

I’d appreciate some help.

1 Like
2

Edit: updated the topic to my latest finding.

3

Thanks for the bug report, I’ve just released a bugfix firmware release v2.2.4 on firmware.striso.org

Since pitchbend is also used for tuning in MPE mode the pitchbend value is still sent at note on, but not reacting anymore on the key x movement.

In normal midi mode it was already working correctly. There it doesn’t send pitchbend at all if it’s disabled.